Feb 01 , 2018

Fence-Stradling Push Box

push box

This little three-sided, handled box keeps your fingers a lot safer when you rip boards on a table saw. And you can make it in about 30 minutes.

Cut a 10-in.-long piece of 3/4-in. plywood the same width as your saw’s fence, and then saw out and screw on a comfortable handle.

Cut a notch on the front end of the1/4-in. plywood sides a little deeper than the board you’re sawing, then screw the sides to the top piece.Mount the push box on the fence. As you saw, the notches lock down on the end of the board to hold it flat on the table. You can further ensure safety and accuracy when you cut narrow boards by using a second push stick in the opposite hand to lightly press the board against the fence. Thanks to Bryan Fehn for this tip.

Related Posts

Handyman Requirements By State
Handyman Requirements By State
Otherwise, you could face fines, removal of your project without compensation, or a dangerous situation at your home....
Read More
What I Regret About Starting a Handyman Business
I made a lot of mistakes when starting my handyman business. Here are just a few: Quoting a painting job and getting...
Read More
How The Coronavirus Will Impact Handyman Businesses And What to Do About It
Updated: 4/27/20 Everyone has Coronavirus on their mind, and rightly so. This could be the most important event in ou...
Read More