Oct 01 , 2018

How to Install a Keyless Drill Chuck

Remove the old drill chuck

Photo 1: Remove the chuck screw

Use the chuck key to lock the jaws of the existing drill chuck fully open, then remove the reverse-threaded screw by turning it clockwise.

Photo 2: Unscrew the drill chuck

Hold the drill down firmly on a solid workbench, then insert the chuck key and hit it sharply with a mallet (turning it counterclockwise) to loosen the drill chuck from the threaded spindle. You may have to repeat this several times to loosen stubborn chucks. Unscrew the old drill chuck.

Photo 3: Install the keyless chuck

Thread the new drill chuck on the spindle (turning it clockwise) and hand-tighten it. Fully open the jaws of the new keyless chuck, insert the old chuck screw (turning it counterclockwise) and tighten it. Install a bit, drill a test hole, then remove the bit and check the keyless chuck for looseness or wobble and retighten it if necessary.

Nearly every 3/8-in. drill sold today comes with a keyless chuck. Pros and do-it-yourselfers alike appreciate how fast they can change drill bits, and the convenience of not having to always hunt up the chuck key. Fortunately, the dwindling number of older reversible drills (corded or cordless) can still be converted to a keyless chuck. You can do the installation yourself in about 20 minutes.

Check the owner’s manual or contact the manufacturer for the correct procedure to remove your drill’s chuck; most show techniques similar to ours. Order the proper keyless chuck online or from the manufacturer, or buy a generic chuck from home centers and hardware stores. Either bring your drill along or record the number stamped into the existing drill chuck (see Photo 1) that tells the thread count for your drill chuck screw. Our stamped code, “THD 3/8-32,” reveals a 32-threads-per- inch count for our 3/8-in. drill.

Begin any chuck replacement by unplugging the tool or removing the battery. To get the old chuck off, remove the chuck screw (Photo 1). These are always reverse-threaded and quite tight, and they may require some muscle power to remove. Our chuck screw is hex-headed, so removing it required an Allen wrench. Then finish up as shown in Photos 2 and 3.

Required Tools for this keyless chuck Project

Have the necessary tools for this DIY drill chuck project lined up before you start—you’ll save time and frustration. [project-tools]

Required Materials for this keyless chuck Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list. [project-materials]

Related Posts

What I Regret About Starting a Handyman Business
I made a lot of mistakes when starting my handyman business. Here are just a few: Quoting a painting job and getting...
Read More
How The Coronavirus Will Impact Handyman Businesses And What to Do About It
Updated: 4/27/20 Everyone has Coronavirus on their mind, and rightly so. This could be the most important event in ou...
Read More
Save Time and Money During Tax Time With This One Simple Tip
Filing your taxes can either be a huge pain in the ass or just a small pain in the ass, depending on how organized yo...
Read More