Oct 18 , 2019

How to Replace a Fluorescent Light Ballast

Replace the fluorescent light ballast in four steps.

How To Replace A Fluorescent Light Ballast
fluorescent light

Photo 1: Remove the bulbs and fluorescent light fixture cover

Unplug the fixture or turn off the power at the main panel. Remove the fluorescent ballast compartment cover to expose the internal wiring and ballast. The attachment method for ballast covers varies widely among manufacturers. It may be attached with nuts or clips or simply snapped into place.

Photo 2: Cut the old ballast wiring

Snip the old fluorescent ballast wiring several inches from the end of the fluorescent ballast with a side-cutting pliers or wire snips. Cut all the wires connected to the fluorescent light ballast. fluorescent light

Photo 3: Unscrew the old ballast

Unscrew the ballast- mounting nut and drop the old ballast free (the ballast will have either one or two mounting nuts). Hold on to the ballast with your free hand to keep it from falling out.

Photo 4: Install the new ballast

Mount the new ballast in the fixture. Strip the electrical wiring back 1/2 in. and connect the matching-colored wires with twist-wire connectors.

When your fluorescent light flickers or makes a loud and annoying hum, a degrading ballast is the cause. The ballast takes in electricity and then regulates current to the bulbs. A typical ballast will generally last about 20 years, but cold environments and bad bulbs can decrease this lifespan significantly. You can get a new ballast at a hardware store or home center and install it in about 10 minutes. However, buying a ballast can be expensive, so consider pricing a brand-new fixture for comparison.

Start by flipping off the circuit breaker or unplugging the light. Remove the bulbs and open up the fixture as shown in Photo 1. There will be four to eight wires coming out of the ballast. Photos 2 and 3 show how to remove the old ballast from the fluorescent light fixture. Confirm that the new ballast matches the old one (photo below) and then install it as shown in Photo 4. After mounting the new ballast, replace the ballast compartment cover and bulbs, and it should be good for another 20 years.

Caution: Turn power off at the main panel before performing this fluorescent light fixtures repair.

Buying a New Ballast

Take the old ballast to the store with you. Compare the new and old ballasts to verify that the wiring diagrams, voltage and current match before installing the new ballast.

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration. [project-tools]

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list. [project-materials]

Related Posts

What I Regret About Starting a Handyman Business
I made a lot of mistakes when starting my handyman business. Here are just a few: Quoting a painting job and getting...
Read More
How The Coronavirus Will Impact Handyman Businesses And What to Do About It
Updated: 4/27/20 Everyone has Coronavirus on their mind, and rightly so. This could be the most important event in ou...
Read More
Save Time and Money During Tax Time With This One Simple Tip
Filing your taxes can either be a huge pain in the ass or just a small pain in the ass, depending on how organized yo...
Read More