Jan 29 , 2019

Replace Your Weather Strip: Bottom Door Seal Replacement

Step 1: Mark and trim the door bottom

Photo 1: Trim the door

Scribe a line on the door 3/8 in. above the top of the threshold for thebottom door seal replacement. Remove the door and carefully cut along the line with a circular saw.

Older wood doors usually rely on a non-adjustable threshold to keep the weather out. If your old door doesn’t seal tight against the threshold, you’re wasting energy. You could screw a surface-applied weather strip to the face of the door, but a door-bottom weather strip is a less obtrusive way to create a good seal.

The bottom door seal replacement we’re using is available at most home centers and hardware stores. If you can’t find a door bottom that’s smooth on one side, you can slice off the barbed flanges from bottom door seal replacement that’s designed for steel or fiberglass doors.

Cut the bottom of the door to allow enough (but not too much) clearance to install the new door bottom. The goal is to create an even 3/8-in. space between the top of the existing threshold and the bottom of the door. Close the door and measure the largest gap between the door and the threshold. If the gap is less than 3/8 in., calculate how much you’ll have to cut off the bottom to equal 3/8 in. Mark this distance on the door at the point you measured. Then use a scribing tool to extend a mark across the bottom of the door (Photo 1).

Remove the hinge pins and move the door to a set of sawhorses. Mount a sharp blade in your circular saw and cut along the line. Protect the surface of the door with masking tape. If you have a veneered door, score along the line with a sharp utility knife before sawing it to avoid chipping the veneer.

Step 2: Install the bottom door seal replacement

bottom door seal replacement

Photo 2: Install the new weather strip

Cut the door bottom to length with tin snips or utility knife. Apply two parallel beads of adhesive caulk the length of the door and nail the bottom door seal replacement to the door.

Cut the door-bottom weather strip about 1/8 in. shorter than the width of the door and tack it to the bottom of the door with a staple gun. Rehang the door to test the fit. If the bottom door seal replacement is too snug, remove the weather strip and trim a bit more from the door. When the fit is perfect, remove the staples and mount the weather strip (Photo 2).

Video: Garage Door Weatherstripping

The Family HandymanGarage Door Weatherstripping Replace cracked and torn vinyl weatherstripping with this easy step-by-step guide. You'll start by removing the old garage weatherstripping, then measuring, cutting, and installing the new pieces. Upgraded weatherstripping will keep your garage warmer in the winter and cooler in the summer.

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
[project-tools]

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
[project-materials]

Related Posts

Handyman Requirements By State
Handyman Requirements By State
Otherwise, you could face fines, removal of your project without compensation, or a dangerous situation at your home....
Read More
What I Regret About Starting a Handyman Business
I made a lot of mistakes when starting my handyman business. Here are just a few: Quoting a painting job and getting...
Read More
How The Coronavirus Will Impact Handyman Businesses And What to Do About It
Updated: 4/27/20 Everyone has Coronavirus on their mind, and rightly so. This could be the most important event in ou...
Read More